PVA Emergence PRO, Руководство по эксплуатации

Страница: 39 / 68

Emergence PRO ™ 3D Printer Manual
Revision C / December 2020
Page 39 of 68
Unload Filament
1. On the Printer Control Screen, select Move and press 50 once in Z values to lower
print bed 50 mm.
2. On Printer Control Screen, set the Active Hot End Temperature to the appropriate
print temperature for material.
3. Via the Extrusion button on the printer display, extract roughly 300 mm of filament
to clear the extruder.
•
Set Extrusion Amount to 100.
•
Set Speed to 50.
•
Press Retract three times.
4. Once filament is retracted, manually wind up the filament spool until the filament is
free from the filament guide.
Perform Test Prints
1. On Printer Control Screen, press File Selection button (Figure 41).
Figure 41: File Selection