DeltaTherm IR Cure Module
Revision B
/
February 2020
Page 22 of 41
The Conveyor Width can be set in Manual mode.
1.
Press to manually enter the target conveyor width setpoint.
•
Touch the screen and a keypad will be shown.
•
Enter the necessary value.
•
Push ‘
ENT
’, and the zone screen will be shown again.
2.
Press to move the current target conveyor width setpoint.
Note: Prior to the move, the machine will check for any boards.
3.
Press to rehome the conveyor width.
Note: Prior to the move, the machine will check for any boards.
Conveyor Jog
Figure 15: Conveyor Jog in Manual Mode
1.
This screen displays the current conveyor width.
2.
Press to adjust the conveyor width. This will jog the conveyor width in a positive or
negative direction.
Note: The clearboard sequence will not run prior to the jog.
