PushCorp SBS81 Series, Руководство пользователя

Страница: 7 / 15

P
USH
C
ORP,
I
NC.
SBS81 Series Manual 5
3.0 Installation
3.1 Mounting the SBS81
The SBS81 Servo Belt Stand is secured by four (4) fasteners passing through mounting
holes located in the Base Plate (See Figure 4). The Base Plate mounting hole locations
are shown in Figure 1. The SBS81 must be securely mounted to keep the unit from
moving during operation. The unit must be mounted level to achieve the desired force
output at the Contact Wheels. A spirit level can be place on the top of the Belt Stand
and shims can be inserted under the Base Plate as required.
WARNING: Do NOT operate the unit without first mounting it securely.
Figure 1. SBS81 Base Plate
The SBS81 attaches with four (4) fasteners, 1/2 inch (12 mm) in diameter. These
fasteners are to be provided by the installer.
3.2 Electrical Connections
The SBS81 requires 208 - 480 VAC 3-Phase 50-60 Hz. power to operate. This should
be supplied to the Power Connector on the Control Box. The electrical interface for
servo motor control, AFD feedback, and Belt Media tracking is operated through the
User Interface Connector. Figure 2 shows a typical manual interface schematic, which
Copyright

PushCorp, Inc. 2019. All rights reserved