purway Crystal Group PUR Quick 6 UF, Руководство по установке

Страница: 3 / 5

2. Take the supplied water-in ball valve and wrap one end with Teflon tape.
Moisten the valve with silicone spray and screw it into the thread of the
3-way water inlet socket provided for this purpose (pict. 5). Cut the
supplied tube with scissors to the desired length. Connect one end of
the tube to the water-in ball valve and tighten it with the nut. Connect
the other end to the water inlet of the first filter of the unit.
3. Drill a hole of 6 mm in the drain pipe. Cut the supplied 6 mm tube with
scissors to the desired length and place one end into the drilled hole.
Seal the hole with silikon gel. Fasten the waste water hose on the drain
pipe with a cable tie or a hose clip.
4. Drill a hole of 12 mm in the sink where you want to place the faucet.
Take the supplied faucet, put the neck of stainless steel on the faucet
body and countersink the faucet into the provided drilled hole. From
below put a washer and tighten it firmly with the nut. Cut the supplied 6
mm tube with scissors to the desired length. Insert the supplied 6 mm
plug into one end of the tube and fasten it with the nut on the cold water
inlet.
5. Open the faucet and fill the unit with water. Check the tightness of all
connections. In the beginning it is possible that the water is a little dark
and some coal dust can escape from the activated carbon block. This is
absolutely harmless and the water will be clear after a few minutes.