www.purposeav.ca [email protected] (888) 470.2211
INSTALLATION
STEP 1: REMOVING THE TV PLATE FROM THE WALL PLATE UNIT
• Remove the bolts 1 using the Allen key to separate the wall plate unit from the tv plate
INSTALLATION
STEP 2: MOUNT WALL PLATE UNIT
Mounting on a Stud Wall (2 adjacent studs)
• Locate the center of the studs using a stud
finder and mark 4 holes
•
Pre-drill top and bottom holes into the
wood studs with a 7/32” drill bit to a depth
of 2.5”
• Fix the wall plate by using the lag bolt
screws (H) and washers (J) (Figure 1)
Mounting on a Concrete Wall
• Pre-drill 4 holes into the concrete using
3/8” drill bit to a depth of 2.5”
• Insert anchor (I) into each of the holes. Tap
until flush with concrete surface
•
Fix the wall plate by using the lag bolt
screws (H) and washers (J) (Figure 2)
WARNING
Wood stud must be a minimum size of
2x4 inches. Lag bolts must be in the
center of the stud. Do not over tighten
lag bolts.
WARNING
Do not drill into mortar joints. Concrete
must be a minimum of 2000 psi density
in order to hold anchor. Ensure that the
anchor is flush with concrete surface
even if there is another layer of ma-
terial. If layer of material is over 3/8”,
custom thicker lag bolts must be used.
Do not over tighten lag bolts.
