RECOMMENDED OPERATING INSTRUCTION
cont.....
• Consult the vehicle owner’s manual prior to using Kojack Hydra Jack and its
components.
• The vehicle must be attached to the tow vehicle before and when jacking.
• Keep work area clean and free of hazzards.
• Keep children at a safe distance whilst working on vehicle.
•
Kojack Hydra Jack should be used on firm, level ground, wherever possible.
• Do not occupy the vehicle whilst lifting or working on it.
• Chock all wheels before using Kojack Hydra Jack to lift the vehicle.
• No person should place any portion of their body under the vehicle supported only
by the Kojack Hydra Jack.
• After the vehicle is raised to the correct height, secure it by placing the Prop-Jack
under the chassis.
OPERATING INSTRUCTIONS
TO LIFT
1. Join the three sections of the Jack Handle together.
2. Unscrew the Cap by turning it anti-clockwise until it is about 5cm above the jack.
3. Fit the two sides of the Collar around the threaded section under the Cap.
4. Fit the Ball or Trailer Mate Adapter over the Collar.
5. Insert the Hex Key into the Grub Screw located on the Adapter and tighten by
turning it clockwise until firm. Repeat for the other Grub Screw.
6. Position Kojack Hydra Jack under the ball socket or trailer mate mount on the
vehicle.
7. If able, unscrew the Cap by turning it anti-clockwise until it will no longer turn.
8. Insert the notched end of the Jack Handle into Kojack Hydra Jack Release Valve
and rotate clockwise to close the valve.
9. Place the Jack Handle in the Tube mounted on the Kojack Hydra Jack and move
the Jack Handle up and down to raise the vehicle.
10. If the jack is unable to lift the vehicle to the desired height, use the Prop-Jack to
secure the vehicle.
11. Insert the Jack Handle into the Release Valve and gently turn anti-clockwise to
IMPORTANT NOTICE
During shipment and handling, air can becomed trapped in the hydraulic system
degrading the performance of the Hydra Jack. This can also occur when changing
and topping up hydraulic fluid. To purge air from the system, lower the Hydraulic Ram
as far as it will go, place the jack horizontally with the Oil Filler Cap facing upwards
and remove the cap, which will allow the air to escape.
MANUAL Hydra Jack - RV Jacking Kit 4000kgs.indd 5
23/07/2013 12:44:04 PM
“More information https://www.caravansplus.com.au"
