TROUBLE SHOOTING:
UNIT FAILS TO OPERATE:
Check the Isolation Switch (29) is in the on position.
Check that the batteries have been installed in the remote correctly and work. If not, install or replace
the three ‘AAA’ batteries. Refer page 10 to install batteries in the remote.
Check that the 12V Battery used to power
Ego QuicKEY™
is fully charged. The Control Unit will
indicate if the charge in the battery is low when the Blue LED is on and the Red LED is flashing twice
slowly. If the charge is low, recharge the battery or if this fails to improve the level of charge in the
battery, replace it.
Check the Remote is ‘paired’ with the Control Unit. Refer page 11
to pair the Remote.
BATTERY VOLTAGE:
Automotive batteries are rated at 12V, however a fully charged battery will deliver a charge closer to
13V. A Voltmeter reading of 12.7V or higher indicates that the battery is 100% charged, 12.5V is three
quarters charged and 12.4V can indicate the battery is only 50% charged. Ego QuicKEY requires an
output of at least 12.5V to function.
Check the power cable is connected to the battery.
Check the condition of the power cable and terminals. If the cable or terminals are damaged replace
and if the terminals are corroded clean.
Check that the battery is not overloaded. The Control Unit will indicate the battery is overloaded when
the Blue LED is on and the Red LED is flashing continuously. If the Control Unit indicates the battery is
overloaded, firstly check your charger to ensure it is operating correctly. Secondly connect a 12V device
to discharge the battery to the optimum level. If the steps do not rectify the matter replace the battery.
REMOTE CONTROL:
The Remote Control is programmed to operate within a distance of 0-5 metres from the Control Unit.
If there is no signal between the Remote and the Control Unit
Ego QuicKEY™
will not operate even
though the LED on the Remote is illuminated.
UNIT OPERATES INTERMITTENTLY:
Check the points detailed in ‘UNIT FAILS TO OPERATE’ and rectify where necessary.
With the rollers engaged, check how much the voltage drops with a voltmeter when the Remote is
activated. If the voltage immediately drops below 10 volts, recharge or replace the battery.
ROLLERS SLIP ON WHEELS:
Check that the rollers and tyres are clean, especially free of oil and grime. If contaminated, clean with
an appropriate cleaner.
Check the tyre pressure on both wheels and where below the recommended pressure inflate. Refer to
the manufacturer’s handbook for the recommended tyre pressure.
Check that the distance between the Roller and first point of contact with the tyre is 20mm on both
sides. If not adjust the distance between the rollers and the tyres as detailed in the Mechanical Assembly
and Installation instructions.
ERROR MESSAGES:
All error messages will reset automatically after 40 seconds. If this does not occur, switch off the
Remote, then switch off the Isolation Switch for a least 15 seconds. Switch on the Isolation Switch then
switch on the Remote by pressing the power button twice within 1 second.
IF IN DOUBT OR IN THE EVENT THE FOREGOING TROUBLE SHOOTING
INSTRUCTIONS FAIL TO RECTIFY THE ISSUE, CONTACT THE DEALER
EGO QUICKEY™ WAS PURCHASED FROM OR PURPLE LINE.
Page 14
EQR130 1308 Ego QuicKEY User Manual Final.indd 14
30/07/2013 2:33:31 PM
