Copyright @ 2011 PurGro Electronics, LLC
All Rights Reserved
Page 36 of 47
The radio in your Panelboard has about the same range about the same as a wireless LAN since it uses
the same 2.4 GHz radios. You’ll get best results with the Panelboard in the same room and within
sight of your GroBot. If you put it in a box, make SURE the box is plastic and not metal!
120 Volt Power
The Panelboard runs on 120 volts AC, and you need to
wire the connector at the top, left of the board that’s
labeled
120V
to a 120v circuit to power it up. The green
power LED will light, and the red LED on the radio will
flash every so often.
Wiring Eight (8) Double Pole Relays
Each relay has two terminals on the left and two on the
right. You can connect incoming power from a circuit
breaker the pair of terminals on the left, and the load to be
powered to the two terminals on the right. When the relay
is energized, the load is connected. That’s all there is to it.
Содержание GroBot Evo 3.12
Страница 12: ...Copyright 2011 PurGro Electronics LLC All Rights Reserved Page 12 of 47 This page is also blank ...
Страница 17: ...Copyright 2011 PurGro Electronics LLC All Rights Reserved Page 17 of 47 External Devices Part II ...
Страница 27: ...Copyright 2011 PurGro Electronics LLC All Rights Reserved Page 27 of 47 Setup Part II ...
Страница 34: ...Copyright 2011 PurGro Electronics LLC All Rights Reserved Page 34 of 47 ...