User Manual
PT-MA-HD88HDBT
34
Note:
The IR receivers which are connected to HDBaseT receivers also can receive
the IR signal of the IR remote, so the matrix switcher also can be controlled by the IR
remote at the far-end HD
BaseT receivers’ position. The IR remote
-control mode can
be enabled or disabled by sending RS232 command “IRRCM[XX]ON.”/
“IRRCM[xx]OFF.”
([XX]=00~04). Please refer to the
8.3.1 System Control
for more
details.
7.2
IR Pass-through Control
The matrix switcher supports bi-directional IR pass-through, allowing the devices to
be controlled by both source and destination ends. This section provides connection
and switching examples to illustrate possible configurations.
7.2.1
Control Local Input Device from Remote
The same basic principle applies when controlling the local input device from the
remote location.
⚫
Control local input device through IR OUT port
Example: Switch HDMI input 3 to HDBaseT output 4.
Connect an IR receiver to
IR IN
port on the receiver, then connect an IR emitter to the
IR OUT 3
on the matrix switcher. The third input source can be controlled through its
corresponding IR output port. The connection diagram shown as below:
Содержание PT-MA-HD88HDBT
Страница 74: ...User Manual PT MA HD88HDBT ...
