Do’s And Don’ts
Your NanoComm GA has been manufactured to extremely high standards,
however, we recommend that you follow these simple steps to ensure the
headset gives high quality un-interrupted performance for years to come.
Do’s:
Always ensure the white dot shown on the microphone is pointing toward
the mouth. Ensure the mic is placed close to the lips. If the lips lightly
brush the windshield whilst talking then the mic is optimally positioned.
When connecting the headset to the custom-made earpieces, always
ensure this is done in a horizontal direction. Insert one side first then
apply gentle pressure to the other side until an audible click is heard (see
diagram 1.1).
When removing the headset from the custom-made earpieces, always
make sure this is done in an upward (vertical) direction (see diagram 1.2).
When not in use, always ensure the NanoComm GA is packed into the carry
case supplied and not subjected to undue rigours.
Ensure earpieces are cleaned on a regular basis. Earpieces can be cleaned
using regular baby wipes or alcohol swaps, available from a chemist.
NEVER SUBMERGE EARPIECES IN WATER.
Don’ts:
Never remove the plugs from the avionic equipment by pulling on the
wires. Always grasp the plugs firmly before pulling.
Never attempt to disconnect the headset from the earpieces by pulling the
cables only.
Never offer your NanoComm GA to another person to use. The earpieces
are custom-made exclusively for you and will not offer the same level
protection or comfort to anyone else.
1.1 Connecting
1.2 Removing
Grip under connector
then pull up and out
Place connector under ring and push down
Never pull cables
