2
Installation & Operation Manual
Copyright © Puretec Pty Ltd 2020
Introduction
Introduction
Setup
General Operation
Once the batteries have been installed the display will briefly show the
capacity countdown (factory set to 30,000 Ltr) and the the display will enter
sleep mode. To view the three active screens (capacity, live flow rate and
time) press the DISPLAY button and use this button to scroll through the
different screens.
The PTE80 is factory set with a capacity of 30,000 Ltr and a time of 180
days.
The display will return to sleep mode 10 seconds after any activity, to
reactivate the screen push the DISPLAY button.
Install Batteries
Slide off the cover case of the battery compartment, and install
(2x) AAA batteries. Then slide the cover case back.
DISPLAY
RESET
DISPLAY
RESET
Thank you for purchasing a Puretec PTE80 Water Filter Monitor. The Puretec PTE80 monitor combines a
microprocessor and a paddlewheel / turbine flow sensor to provide exact measurement and monitoring
of the water flow rate and volume. The filter monitor can be used with water filters, coolers and any
water dispenser to help end users or service technicians measure water dispensed and monitor the
filter life. This helps to ensure that the filter is functioning within the specified service life.
Connecting Fitting
Fitting kit to suit 1/4” tube, 3/8” Tube & 3/8” female BSP.
Setting Capacity and Timing
Hold the
DISPLAY
button for two seconds, then press
RESET
button and release both of the buttons. The PTE80 will go into
the setting procedure. The digits will flash to notify you that the setting procedure is on.
Содержание PTE80
Страница 4: ......
