© 2019 GOJO Industries, Inc. All Rights Reserved
Step
5. Open the 8 Series dispenser by pressing in the
left and right buttons on the side to release the
door on the dispenser.
6. Discard the circuit board cover.
7. Insert the module by aligning the module
connection receptacle with the SMARTLINK
connector on the pumphouse.
8. Load the refill into the dispenser and l
dispenser door back up to close it (if you are
installing using adhesive for the dispenser, utilize
the refill collar shipped with the modules
than the full refill to ensure proper adhesion
9. Once the module is installed dispense 3x so the
module can recognize what dispenser it is
connected to.
10. Confirm on the ONVATION Installer App that the
module has ‘checked-in” with the ONVATION
Hub.
GOJO Industries, Inc. All Rights Reserved
Illustration
pressing in the
left and right buttons on the side to release the
Insert the module by aligning the module
connection receptacle with the SMARTLINK
Load the refill into the dispenser and lift the
(if you are
dispenser, utilize
the refill collar shipped with the modules rather
than the full refill to ensure proper adhesion).
ispense 3x so the
module can recognize what dispenser it is
Installer App that the
in” with the ONVATION
Page
2
of
6
