PureLink by Dtrovision
7
1-5 Video Connection
Video Connection
1. Turn off the whole system before connecting.
2. Connect your video source’s DVI output port to the DD-120’s DVI input port using
standard DVI cables (not included).
3. Connect your DVI display’s DVI input port to DD-120’s DVI output port.
4. Plug the 5V power supply to DD-120
5. Plug the 5V wall mount power supply into the wall outlet.
6. Turn on DD-120
7. Turn on your monitor
8. Turn on your video source.
9. Output# 1 and #2 status light will be lit if everything is properly installed.
EDID Management
PureLink DD-120 is capable of capturing and storing EDID of the monitor that is
connected to DD-120. It is essentially important that source graphic adapter must
recognize and understand the EDID of the connected monitor correctly in order to
describe supported display mode to graphic adapter.
Please follow the next instruction of how to save EDID on DD-120
1.
Connect a monitor to output # 1 of DD-120
2.
EDID indicator light will blink about 2-3 times, if EDID is successfully saved.
3.
Please note that EDID indicator light will blinks 5-6 times, if EDID writing is failed.
In case EDID writing fails, you should check your physical connection.
4.
Reboot DD-120 for the change to take effect.
***Notice***
Please note that a factory default EDID is set to WUXGA resolution. Thus you need to
save the EDID before you turn your system on.
