Puredry PDDW 12100 Famous, Руководство пользователя

Страница: 22 / 56

22
dehumidifier and when the air temperature outside increases the windows
should clear of condensation

The dehumidifier is not a heating device. What could be the cause of
warm air being extracted?
The desiccant dehumidifier Rise operates with an electrical resistance that
warms up the desiccant material. As a result, the temperature of the outgoing
air has been increased to 10-12
o
C comparing to the room’s temperature. This
doesn’t denote in any case that this device can be used as a heating appliance

Tank full indicator turns on but the water tank isn’t full. What could
be the cause of it?
When the full tank indicator turns on but the water tank isn’t full, check the
above plastic cover of the water tank. It has to be correctly installed in order the
water level sensor operate normally

The unit doesn’t start

Make sure the dehumidifier’s plug is placed completely into the socket

Check the house fuse/circuit breaker box

Check whether the power cord is damaged

Check the water bucket, if it is full and empty it

Check if the dehumidifier has reached its defined level

Make sure the water bucket is positioned properly

Room temperature is lower or higher than the advised operational
range

Check whether the humidity level has been set in high levels

Dehumidifier does not dry the air as efficient

Make sure that the dehumidifier has been operating enough time to
remove the moisture

Make sure there are no curtains, blinds or furniture’s blocking the front
or back of the dehumidifier

The humidity sensor may not set low enough

Make sure you have cleaned the filter as suggested. Clogged filter may
result in reduced performance

All house exits (windows doors etc) where the dehumidifier is
operating, should be shut

Room temperature is below the advised operational range

There is a kerosene heater or something giving off water vapor in the
room

The room that the device is placed is bigger than suggested

The humidity level is too high

The unit makes a loud noise when operating