Puredry PDD 8519 FAMOUS, Руководство пользователя

Страница: 12 / 40

12 EN
CHECK LED INDICATOR
Blinks when the dehumidifier detects an error. In most cases it illuminates because
the air inlet is blocked, which results in the interior of the dehumidifier being
overheated. Clean the filter, make sure the dehumidifier is not next to a heat source
or is covered, and restart the dehumidifier after 10 minutes.
FULL LED INDICATOR
Blinks when the water tank is full and you need to empty it or when the tank is not
properly installed.
•
•
Note: The room humidity display and humidity settings are
displayed with single or two LEDs, e.g. When both 40% and
50% L EDs are illuminated it means 45%.
Note: If the unit malfunctions, an alarm system will activate
and the unit will automatically shut down.
Internal Over Heating Protections : During operation,
malfunctions may occur if the air intake or the air outlet are
obstructed or blocked by objects. This can cause high internal
temperatures and the appliance will automatically shut down. In
this situation the dehumidifier will set off automatically.
Tipping Protection : The unit has a heater inside, to avoid
overheating, the unit is equipped with a tipping switch that
automatically shuts down the device in the event the unit tips over.
SMART S AVE E NERGY MODE
When the unit drops the humidity level to the level the user set, the unit stops
dehumidifying and the fan continues to operate for the next 2 minutes (for internal
cooling). The unit stops and gets into smart save energy mode in which it won't operate
for the next 30 minutes. After 30 minutes the fan will start to operate for 5 minutes
checking the humidity level of the room. If the humidity level is 5% higher than the
humidity level the user set then it will start to dehumidify. If not it will get in a pause of
another 30 minutes.