www.PyleUSA.com
www.PyleUSA.com
PRODUCT USE
CHARGING OF MAIN BODY
POWER ON / OPERATING / PAUSE / POWER OFF
CHARGING STATUS
DOCKING STATION
MAIN BODY
Charging
status
chart
Before charging The red lights on
The orange light Is on (low battery)
During charging The blue light flashes The green light Hashes
Fully charged
The blue light flashes The green light keeps on
• Notes:
1. Please make sure the docking station is connected well with the adapter.
2. If you will not use the cleaner for a long time, please fully charge the cleaner and
tum off. Please charge the cleaner every 3 months to avoid over discharge of the
battery.
• Poweron
Power on the main body by turning on the power switch and the main body will
be in standby mode.
• Put the auto charging docking station in place and
connect the adapter. The red power indicator light
on the auto charging docking station keeps on.
Notes:
Place the docking station along the wall. No
obstacle or hollow areas 2m away from the docking
Station in front and 0.5 on the left and right (Refer to
Figure)
• The following three methods can be used to
charge the main body.
A: Automatic return
When the machine is low battery at work, the orange
indicator light will be on and a buzzer will alarm the
low battery, then the machine will enter the state of
looking for the docking station and match the
docking station automatically for charging.
B: Artificial selection
When the main body is in standby state or working,
press the Docking key, the main body will search for
the docking station for charging
C: Manual operation
Place the main body on the auto charging docking
station manually. Pay attention to the well contact
between the charging pole pieces at the bottom of
main body and the charging pole pieces of docking
station.
• Operating:
Operate the machine by pressing the start key on the robot, it will
enter working state.
• Pause:
Pressing the start key on the robot, it will pause and enter standby state
• Power off:
Turn off the power switch of the main body, robot is powered off.
CLEANING MODE
In order to adapt to different ground environment and achieve more thorough
cleaning, the main body is equipped with various cleaning modes.
• Auto cleaning mode
Press the key on the main body, or the Auto clean key on remote control, the main
body will enter Z mode, and in specific situation, it will enter edge cleaning mode.
• Spot cleaning mode
Press Spot clean on remote control, the main body will enter spiral mode of
cleaning in a range of about 1 m2 area, and will stop after 2 minutes of cleaning.
• Edge cleaning mode
The robot will clean along the wall under this mode, and will enter auto clean
mode when finish edge cleaning.
• Spiral cleaning mode
The robot will clean in left or right spiral clean mode, and will enter auto clean
mode when finish spiral cleaning.
Velcro
ASSEMEMBLE THE MOP
• If you need to use the mopping function,
please take out the mop and stick it on the
bottom of the main body as per picture.
Remark:
Make sure the mop is stuck smoothly and
aligned, the mop is for dry mopping only,
avoid using liquid.
05
04
