Connect the power supply unit to a 230 V power outlet before inserting the plug of
the flexible cord into its connector located on the rear of the control unit.
Put the handpieces delivered with this unit into their corresponding penholders.
Then insert the plug of the pigmentation-handpieces into one of the eligible
connectors 1 / 2, the plug of the softlaser-handpiece into the eligible connector 3.
For activating the device press its on/off key. Now the machine is in its basic
programm and the connector 1 is activated. In this basic programm all speeds can
be used in steps at 5 between 90 to 250. In all other programms the starting
speeds are set individually for lining, filling and can be changed in steps of 5 for
droping speed and increasing.
If the laser handpen icon is choosen, the foot pedal service is off as well as the
programm and the speed button. Select the drive button for switching on and off
the laser handpen.Then the laser is working on its set modus, no further set up is
required.
For operating the unit by its RF-cordless foot control switch, please provide for
having:
- inserted the block alkaline battery (9V) into the foot control switch;
- turned the rotary selector switch underside the foot control switch in the same
position like that of the rotary switch located under the key panel (each selectable
from 0 to F);
When selecting a position between 0 ... 7, a permanent pressure on the foot
control switch is required for operating the handpieces.
When selecting a position between 8.... F - press the foot control switch shortly
for putting the handpiece into operation. Handpiece operation will be stopped
after pressing it shortly again.
Servicing and care of the device
Standard set
Before requesting service Repair Complaint
Before servicing the device disconnect it from the mains.
Clean the unit from time to time gently with a lint-free cloth (probabely lightly
moistened with a readily soluble antiseptic, e.g. 50% 1-propanol solution in water).
All anodized surfaces of the permanent make-up device and its accessories should
have to be cleaned with LYSETOL MED. This cleaner is DGHM registered and
complies with the requirements of hygiene.
Before using other antiseptics, please pay attention to the corresponding user
instructions and/or ask your supplier for information.
In case of malfunction check first, if the power supply unit is properly connected to
the corresponding line voltage mains outlet.
If the permanent make-up device still proves to be defective, please contact your
next authorized service workshop or send it back to the manufacturer for a general
technical check up or repair.
Complaints have to be directed to your supplier.
Control unit
RF foot control switch
Power supply unit
Pigmentation handpiece
Instruction manual
optional:
Pigmentation handpiece
Softlaser-pen
Getting started Precautions Unit operation
The device has been manufactured in compliance with the relevant German VDE-
safety rules and supplied to the customer in perfect technical conditions. Only
connect this device to properly installed mains power sockets. The mains voltage
must always correspond to the primary level marked on the identification plate of
the power supply unit. Never try to open the device and repair it yourself. Any
maintenance or repair must be carried out by fully qualified technicians, authorised
therefore by the manufacturer. For trouble free use do only operate this device
indoors.
Switch off the device immediatly and protect it from improper and/or unauthorized
use in any case of danger or malfunction, such as:
·
visible defects of the device or its accessories;
·
performance faults;
·
storage under unfavorable conditions for an extended period of time;
·
damage in transit and/or heavy mechanical stress (push, drop etc.)
during transportation.
Please refer in such a case to ...requesting service.
Make sure that the instrument will be always placed on smooth surfaces and
operated only under supervision of trained persons.
Control unit
