11
Options available in FM
FM tuning mode
Seek
When you turn the
Tune
dial, the radio tunes to the next station with a good signal.
Manual
When you turn the
Tune
dial, the radio tunes up or down the FM frequency range by 0.05 MHz.
FM stereo mode
Choose from Stereo or Mono (default). Mono may improve audio clarity where stereo signals are
weak.
General options
Adjusting the display
You can adjust the brightness and time-out duration of the display for when the unit is switched
on and in standby. To change display options:
1. Press
Menu
, scroll to ‘Display settings’ and push the
Tune
dial.
2. Now choose either ‘Active’ to change settings that apply when the unit is switched on, or
‘Standby’ to change settings that apply in standby.
Changing the display time-out duration
Select ‘Duration’ and choose from the following two modes:
Always on
The screen is always set to your preferred brightness level.
Timed off
The screen is set to your preferred brightness level when a button is pressed and
then switches off after 7 seconds of inactivity.
Changing your preferred brightness level
Select ‘Brightness’ and choose from the following options:
Automatic
The brightness of the screen adjusts automatically depending on the ambient light
levels in the room (default).
1–10
Turn the
Tune
dial to vary the brightness level between 1 (very dim) and 10 (very
bright) and push to confirm your preferred setting.
Screensaver
EVOKE-1S has a screensaver that appears when the unit is left unattended whilst on or in
standby. To avoid screen burn-in over a long period, it is recommended that you do not switch the
screensaver off. Two options are available:
On (default)
The screensaver appears after no buttons have been pressed for 15 minutes. Press
any button to exit the screensaver and operate the radio.
Off
Screensaver does not appear.
OLED displays are more power-
efficient than LCD displays because
they do not require a backlight.
(
Menu
> FM tuning mode)
(
Menu
> FM stereo mode)
(
Menu
> Display settings)
Setup options
