1. Place the Rubber Washers into the (TA1) Tap Adaptor (thin first, then the thick Washer.
Some taps may only require the thicker Washer).
2. Screw the Tap Adaptor up into the inside of the tap and tighten.
3. Attach the Diverter to the bottom of the Tap Adaptor.
4. Complete the installation process (SEE STEP 3).
Installation ‘B’: The Thread is on the Inside of the Tap.
TA1
Installation ‘C’: NO Thread - Small Tap Diameter.
1. Select the correct sized black Grommet to fit on the Internal Tap Adaptor (TA2)
which will then go up into the inside of the tap (there are 3 different sized black
Grommets that can be used for different sized taps).
2. Push the black end of the Adaptor up inside of the tap.
3. Using a flat head screwdriver on the silver plate, tighten anticlockwise until the black
Grommet widens and holds firmly to the inside of the tap.
4. Attach the Diverter to the bottom of the Tap Adaptor.
5. Complete the installation process (SEE STEP 3).
Installation ‘D’: NO Thread - Large Tap Diameter.
1. Remove the internal white Rubber Insert (Sleeve) from the large Sleeve.
2. Push the black Washer into the inside of the large white Sleeve (the one with thread
attached).
3. Push the Tap Adaptor up and over the outside of your tap as far as possible (for
thinner taps, insert internal white Rubber Sleeve).
4. Slip the steel Clamp over the white Rubber Adaptor as high as possible on the
Adaptor to avoid splitting.
5. Using a Flat head screwdriver, tighten the Clamp firmly.
6. Attach the Diverter to the bottom of the Tap Adaptor.
7. Complete the installation process (SEE STEP 3).
1. Remove the Aerator from the end of the existing cold water tap.
2. Screw the Diverter straight up onto the end of the tap.
3. Complete the installation process (SEE STEP 3).
If the diameter of the tap is too small to fit the Diverter. Please proceed
to installation ‘C’.
If the diameter of the tap is too big to fit the Diverter, please go to installation ‘D’.
Installation ‘A’: The Thread is on the Outside of the Tap.
