Strobe Can manual.doc
2/6
SAFE USAGE OF THE LUMINAIRE
2
INSTALLING THE UNIT
3
FITTING THE LAMP
4
DEDICATED CONTROLLER MODE
4
MAINTENANCE
5
KEEPING THE UNIT CLEAN
5
TROUBLESHOOTING
5
TECHNICAL DATA
6
ELECTRICAL DIAGRAM
6
Please note that as part of our ongoing commitment to continuous product development, specifications are subject to change
without notice. Whilst every care is taken in the preparation of this manual we reserve the right to change specifications in the
course of product improvement. The publishers cannot be held responsible for the accuracy of the information herein, or any
consequence arising from them.
Every apparatus is tested completely and packed properly by the manufacturer. Please make sure the packing and / or the
apparatus is in good condition before your installation and use. Should there be any damage caused by transportation, consult
your dealer and do not use the apparatus. But any damage caused by improper use will not be assumed by the manufacturer
and / or dealer.
THESE ITEMS ARE PACKED TOGETHER WITH THE UNIT
Mounting Bracket (1 PCS)
M6 Knob for mounting bracket (2 PCS)
Dedicated controller PR-1388 or PR-1389 (Optional)
This manual (1 PCS)
Thank you for purchasing the product Strobe Can, PR-2288.
The Strobe Can adopts advanced design and manufacturing and it complies to CE norms and
standards. The cover is made from high intensity and heat–resistant complex plastic. The structure
design is simple and portable. The unit is convenient to be hung and the angle of the body is easy to
be adjusted. The Strobe Can may be used as a stand-alone unit, or linked to a dedicated controller.
The strobe speeds of the luminaire may reach 20 flashes per second and the strobe speeds can be
adjusted, so it is suitable for use in stage, disco, night club, artistic applications and so on
.
When unpacking and before disposing of the carton check there is no transportation damage before
using the unit. Should there be any damage caused by transportation, consult your dealer and do not
use the apparatus.
The unit is for Indoor use only, IP20. Use only in dry locations. Keep this device away from rain and
moisture, excessive heat, humidity and dust. Do not allow contact with water or any other fluids, or
metallic objects.
The projector is not designed or intended to be mounted directly on to inflammable
surfaces.
The unit is only intended for installation, operation and maintenance by qualified personnel.
High voltage Inside the luminaire.
Avoid shock hazard.
The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent
surfaces. Be sure that no ventilation slots are blocked.
Do not project the beam onto inflammable surfaces, minimum distance is 3m.
3m
ACCESSORIES
INDEX
INTRODUCTION
INTRODUCTION
SAFE USAGE OF THE LUMINAIRE
