Pure Photonics
Confidential
PPEB700 ITLA and micro-ITLA eval board
Page
5
of
11
With the board raised the micro-ITLA can be positioned in place below the board. It is
recommended to put the front screws already in place and then slide the micro-ITLA in
place (the screws will help finding the mounting holes). The holes in the board allow for
access to the screws below the board. After installation, the board can be lowered gently
onto the micro-ITLA. The system is self-aligned and the micro-ITLA connector will connect
properly, though care is recommended). A gentle push on the board may be needed to
ensure full contact.
It is recommended to always fixate the position of the board with the nuts on the posts. In
case the ITLA installation is used, the board can rest on the stand-offs. In case the micro-
ITLA is used, the board can rest on the micro-ITLA.
The assembly is equipped with rubber feet. In case a better thermal behavior is requested,
the feet can be removed and he plate can be installed on a larger heat sink surface
directly.