Version 1.0 8.05.2007
Using the Manual Override
There are 3 types of override available
1.
Press the
“+ or –“
button for a temporary override until the end of the current time block.
2.
Press the
“+ or –“
button for a temporary override then repeatedly press the “
Day and Time
”
button repeatedly to set the length of time for the override to a maximum of 9 hours.
3.
Press the
“+ or –“
button then the “
hold
” button to give a permanent override.
Press “
set and return
” at any time to return to the normal programming.
Recommended Settings
Starting with the hallway we recommend that you stagger the starting times for your thermostats in
all the common areas of the house to start asking for a higher than normal temperature (typically
around the 22° mark) during the night rate period. Bedrooms should only be brought on for 1 to 2
hours at this time.
A lower temperature (typically around the 18° Mark) should then be requested during the day and
then raised again if you wish during the evening time (typically around the 21° Mark for a sitting
room).
Allow 1-2 hours for the under floor to raise a room by a couple of degrees and allow 1-2 hours for it
to cool. The time this takes can vary depending on the floor coverings and external air temperatures.
During the summer months reducing the temperature to 10° and pressing the hold button to give a
permanent override will stop the heating in that particular zone.
Night Rate is between 2300 and 0800 during winter and 0000 and 0900 in summer.
