– 8 –
Getting Started
SETTING UP & OPERATING YOUR CARBON FILTER WATER DECANTER
Please use care when handling the filter. Avoid dropping, dragging or setting it on
a sharp surface.
STEP 1: PREPARING THE FILTER
A. Rinse the Signature Carbon Filter under cold water for one minute
to remove any loose particles.
STEP 2: ASSEMBLING THE LID
A. Slip the washer onto the screw and insert the top of the screw
through the hole in the lid.
B. Hand-tighten the knob onto the screw.
STEP 3: ATTACHING THE SPIGOT
A. Remove the nut from the spigot.
B. Remove protective film from the spigot washers and place one
spigot washer and one rubber washer on the spigot, as shown.
C. Insert the spigot through the hole in the lower water container and
secure it with the other rubber washer, spigot washer and nut.
D. Hold the nut in place and tighten by turning the spigot clockwise
until it’s in an upright position.
E. Hand-tighten the nut onto the spigot until it creates a seal (3–5
turns). Spigot washer(s) may not be flush to unit.
We’ve designed the Pure Company Carbon Filter Water Decanter to make set up and operation quick
and easy. See the instructions below—or visit us at thepurecompany.com/support to watch the video.
Lid Knob
Lid
Washer
Screw
1
Lower Water
Container
Spigot
Spigot
Washer
Spigot
Washer
Rubber
Washer
Rubber
Washer
Nut
3
