TM
URFMBSM
Urban Floor Standing Bath Shower Mixer
BS01551125. ZX
III Installation Diagram:
IV Installing Steps (As shown in figure 1~13):
Ø12 Hole
Protection Cover
Inlet Base
Hexnut
Flat Shim
Spring Shim
Expansion Bolt
I Installation Notice
1. Install water supply lines in accordance with this manual.
2. The waste should be installed in the location of the mixer.
3. Install the tap only after the completion of interior house
decoration in case paint or other chemicals erode the
chrome surface.
4. Clean pipes to get rid of mud, sand or other debris blocked
in pipes.
5. Check whether the threads can be matched. Otherwise, too
much force applied to the wrench will damage the mixer.
6. After installation, check all the joints to make sure they are
firmly connected. Turn on and off repeatedly to ensure
there are no leaks around the joints.
7. Pass the manual to the user.
II Operation Notice
1. The product is used between water pressure 1.0 - 4 bar,
water temperature 4~90°C.
2. Do not hang heavy things on the mixer.
3. Always clean the surface of chrome to keep it bright.
Attention: Please do not use inappropriate tools such as
sharp brushes, rough sponges, scouring pads or corrosive
detergent to clean the tap, and we do not recommend
that you use any household detergent, because its
formula may damage the chrome. Please clean the with a
wet cloth and soapy water after each time of usage. Then
rinse the soap off with clean water and dry with a soft
cotton cloth.
4. When the room temperature drops to below 0°C, take
necessary measures (such measures as keeping the tap
warm and closing windows) to prevent the tap from
being frozen or even broken.
5. You should open the cold and hot water in turn and adjust
the temperature before washing or showering. To avoid
scalding, regulate the water temperature before washing
or showering and do not touch the hot part of the mixer.
6. Do not disassemble the product unless you are an expert.
Drill 4 Ø12 holes on the floor in
accordance with the inlet base
(make sure that the printed mark
for hot water faces to the bathtub).
Install 4 expansion bolts to the
inlet base and tighten them
with hexnuts.
