mm - hole saw (high speed steel or marble saw) - Phillips and
slotted screwdrivers - scissors - 16 mm and 14 mm wrenches
–
needle-nosed pliers.
3.
Make sure that you have all the necessary connection components
at hand.
4.
Turn off the water and power supply before starting installation.
CAUTION:
To open the
hose quick connectors
, push the small safety
ring inwards. Hold it down and pull out the hose.
For mounting, insert the hose back into the coupling as far as possible and
secure it by pulling the hose out slightly, thus activating the inner circlip.
B. Installation of reverse osmosis system
1. Close the inlet valve and unscrew the metal hose. Take the
supplied 3-way socket and connect one end to the water outlet
valve. Screw the other end of the unscrewed metal hose to the
3-way sleeve with the nut.
1. Take the supplied water inlet ball valve and wrap one end with
Teflon tape. Spray the valve with some silicone spray and screw it
into the provided thread of the 3-way water inlet sleeve. Take the
supplied 9 mm hose and cut it with scissors to the desired length.
Connect one end of the hose to the water inlet ball valve and screw
it tight with the nut. Connect the other end to the water inlet on the
1st filter of the device.
