5
12. A heater has hot and arcing or sparking parts inside. DO NOT use in areas where gasoline,
paint, explosive and/or flammable liquids are used or stored. Keep unit away from heated
surfaces and open flames.
13. Avoid the use of an extension cord because the extension cord may overheat and cause a risk
of fire. However, if you have to use an extension cord, the cord shall be NO.13 AWG minimum
size.
14. To avoid fire or shock hazard, plug the unit directly into a 120 V AC electrical outlet.
15. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on plug,
DO NOT unplug by pulling on the cord.
16. Always unplug the unit before moving or cleaning, or whenever the heater is not in use.
17. Use only for intended household use as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use
of attachments not recommended or sold by unauthorized dealers may cause hazards.
18. Always use on a dry, level surface. Use on ceiling only.
19. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any
solid-state speed control device.
20. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing
so will void your warranty. The inside of the unit contains no user serviceable parts. Qualified
personnel should perform all servicing only.
21. Connect to properly grounded outlets only.
22. This appliance is not intended for use by persons (including children) with reduced physical.
Sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
23.
Children should be supervised to ensure that they do not play with the appliance.
24.
The marketing concerning covering shall be visible after the heater has been installed.
25. SAVE THESE INSTRUCTIONS.
SPECIFICATIONS
Voltage Rating
230V 50Hz
Power Consumption
900/1200/2100W
Unit Size
6
0
(W
)×60
(D
)×34.5
(H)
Unit Weight
3.
5
PRODUCT DIAGRAM
OPERATING INSTRUCTIONS
G.
Place the heater on a firm, level ceiling surface;
H.
The Hook on the ceiling hanging the Patio Heater must be able to undertake a weight 3 or 4 times
that of the Patio Heater itself.
I.
Place the Hook A around the Ceiling Hook and clip on any Ring of the Chain to adjust the height
of the Patio Heater to the Floor.
J.
The distance between the bottom of the Patio Heater to the Floor must be over 6.0 feet.
K.
Plug the Patio Heater into a grounded 220~240V 50Hz power outlet.
L.
Only operate the heater when it is in the upright position.
Our Electric Patio Heater is equipped with Three heat settings
•
The switch on the heater head is used to control the three heat setting. (I) for 900w – (II) for
1200w – (I & II) for 2100W, The 0 position is off.
To operate the heater on high, pull the Switch Cord again. This will cause both the bottom and
top heating elements to glow and radiate heat.
MAINTENANCE
Switch
Box
Heater
Cover
Heater
Element
Chain
Mesh
