Pulse ROIP-400, Руководство по эксплуатации

Страница: 19 / 28

19
ROIP-400 Operation Manual
Copyright 2017 @ Pulse Communication Systems Pvt. Ltd.

If Internet Connection is being distributed to LAN by a Router or
server, then ask Network Admin to unblock Local Port and Remote
Port (
mentioned in ROIP IP Settings) , if blocked. Also ask forward
Port Address (Local Port) to IP Address of ROIP (IP1 or IP2)
Using Port Forward (NAT) feature or DMZ Host feature available at
Router or Server’s Settings Page.
Vox Mode Configuration
If you are using a base radio which does not provide carrier signal on
output pin of accessory connector or using a hand held device to inter-
face with ROIP, use Vox Mode. Configuration for the same is men-
tioned below:

Open “Radio Configuration Page” .

Tick Checkbox of “Vox Mode”

Enter “Vox Delay” as 100

Enter “Vox Threshold” as 5
Multiple Radio connection over single ROIP (Bridge Mode)

If you are connecting two or more Radios (up to 4 Radios) with
each other using single ROIP.

Open “Radio Group config setting” and create Radio Group and
select the permanent share in Group Audio Shared Type.

Open “Server Config setting”
Select the Connection Port on which you want to map with
Radio group.
Select the Radio Port/Group map which you have created .