4.2
4.2
4.2
4.2 Positioning & Transporting
Positioning & Transporting
Positioning & Transporting
Positioning & Transporting
For optimum setup the system is best mounted on a stand at a height of 1 – 1.5 m above the ground.
An optional stand “PA-40 STAND” can be purchased from your local PULSE dealer.
For mobile use, e. g. guided tours or outdoor events, the shoulder strap or the shoulder bag supplied
can be used. Fasten the strap to the eyes (1). For operation inside the shoulder bag, put the active
speaker system into the bag in such a way that the sound from the speaker will be radiated through
the mesh side. To access the operating elements and connections, open the lateral flap of the bag
(Velcro fastener).
4.3 Connections for Microphones & Audio Sources
4.3 Connections for Microphones & Audio Sources
4.3 Connections for Microphones & Audio Sources
4.3 Connections for Microphones & Audio Sources
Always switch off the active speaker system before connecting!
1) In addition to the wireless microphone, a cable connected microphone may be used. Connect the
microphone to the jack MIC IN (7).
2) Audio units with a line output (e. g. CD player, cassette recorder, MP3 player or laptop) can be
connected to the jack AUX IN (8). A cable-connected microphone and an audio unit should only be
connected at the same time if the output level can be adjusted on the audio unit; otherwise the volume
ratio between the microphone and the audio unit cannot be altered.
3) For sound recordings, connect a recorder to the jack MIX OUT (9). The output level is independent
of the position of the control MAIN VOL (11).
4) For PA applications of larger zones, connect an additional PULSE PA-40 to the jack MIX OUT (9).
More units can then be daisy chained from the mix out of the second unit etc.
5 Operation
5 Operation
5 Operation
5 Operation
1) Switch on the unit with the on-off switch and volume control MAIN VOL (11). During operation,
the red LED LO BAT (12) will light up. If it the light flashes, recharge the battery as per chapter 4.1.
2) If a microphone is connected to the jack MIC IN (7) or a unit to the jack AUX IN (8), adjust the
desired volume with the control MAIN VOL.
3) If a wireless microphone or a beltpack transmitter is used, switch on the receiver with the on/off
switch and volume control VOL (3). The red LED PW (5) will light up.
4) Leave the wireless microphone or the pocket transmitter switched off for the time being and
use the rotary switch (4) to select a channel which is free and interference-free.
If the green LED RF (6) lights up after the channel has been selected and with the microphone
or transmitter still switched off, interference or signals of other transmitters are received on this
channel. In this case, set the receiver to a different channel.
5) Switch on the wireless microphone or the pocket transmitter and set it to the same channel as the
receiver. The green LED RF (6) will light up to indicate reception of a radio signal.
6) If a microphone is connected to the jack MIC IN (7) or a unit to the jack AUX IN (8), use the control
VOL (3) to add the microphone signal received. If the wireless microphone or the pocket transmitter is
Содержание PA-40
Страница 1: ......
