SETUP GUIDE
INSTALLING IN A RACK
1. Attach the rack ears to the front sides of the matrix using
the provided screws.
2. Install into rack and connect cabling according to mode of
operation – as described below.
WARNING: To prevent damage, it is important to ensure
adequate ventilation space on the sides of the matrix,
especially around the ventilation openings on the side of the
product enclosure.
CONNECTING THE VIDEO INPUTS
3. Connect HDMI cables from your video sources (e.g. Bluray
player) to the HDMI inputs of the matrix.
Note: It is recommended, for ease of setup, to connect devices
from in order from Input 1 to Input 6.
4. If required, connect a compatible IR Flasher over the
source device’s IR window and attach to the ‘IR Flasher’
port.
Note: Ensure that the IR Flasher is connected to the same zone
as the source device’s HDMI input (i.e HDMI input 3 and IR 3)
CONNECTING THE HDBaseT VIDEO OUTPUTS
5. Connect an appropriate Cat5e or higher grade cable to
each HDBaseT output port you require.
Note: It is recommended, for ease of setup, to connect devices
from Output 1 to Output 4, although this is not necessary.
6. Complete the connection
by attaching the other
end of the Cat cable to
a supplied neo:UltraSR
Receiver’s ‘HDBaseT In’
port. The receiver should
be situated at the output
end (ie. TV).
7. Attached a compatible Episode IR receiver into the neo:UltraSR
Receiver’s IR RX port and attach the bud to the sink device.
8. Finish the connection using a an appropriate high speed
HDMI cable from the output device and connect to the
Receiver’s ‘HDMI Out’ port.
CONNECTING THE HDMI VIDEO OUTPUTS
9. For Output ports 5 and 6, connect sink devices directly via
high speed HDMI cables.
Note: Can also be used in conjunction with a neo HDMI
Extender Set (sold separately) for reaching extended distances.
CONNECTING THE AUDIO OUTPUTS
10. If you wish to use the Audio outputs, please connect cables
to the relevant output - each output zone features Optical
and Digital Coax options.
Note: The audio outputs allow matrixing, please refer to the
full manual to find out more.
CONNECTING TO NETWORK
11. Connect a standard Ethernet cable (Category 5e/6/7) from
the matrix’s ‘Ethernet’ port to your router or a network
switch.
Note: Network connection is required for supporting full
control/remote monitoring features of the product.
