Pulsar PulsarSafeEar, Руководство пользователя, Страница: 3 / 6

Setting up your PulsarSafeEar system
1
. Check contents
x1
PulsarSafeEar
x2 x2
Wall mounting
screws & wallplugs
2
. Trigger Level & delay
3
. Set Trigger Level
156mm
5
. Wall mounting. Use the template provided
below to position the unit on the wall
Master guide set up instructions
x1
5m Power
Extension Cable
Power Supply
with UK, US & EU plugs
x1
Microphone
When setting the trigger level, remember that this is the level at the microphone.
Adjust the level to take account of any distance between the microphone
and noise source.
Brightness
Level
0-9
Add ‘800’ to the dB level to disable the 30 second turn-off delay.
Examples:
Trigger Level = 0 8 5 = 85dB(A) 30 second turn-off delay
Trigger Level = 8 8 5 = 85dB(A) no turn-off delay
Trigger Level = 0 4 5 = 45dB(A) 30 second delay
Trigger Level = 8 4 5 = 45dB(A) no turn-off delay
Trigger Level = 1 0 0 = 100dB(A) 30 second turn-off delay
Trigger Level = 9 0 0 = 100dB(A) no turn-off delay
Trigger Level Settings
Minimum : 40dB
Maximum: 120dB
Microphone
Data Logger
(Optional)
Power In
Power Out
to Remote
Display
4
. Connect Microphone & Power
6
. Connect Microphone & Power
7
. USB Data Logger
a
b
Install the PulsarSafeEar Software
Connect the PulsarSafeEar DL Data Logger to the PC and run the
PulsarSafeEar Software. Configure & start the Data Logger.
An extension cable can be used with the PulsarSafeEar to allow the microphone to be positioned remotely.
This requires an optional preamplifier, microphone capsule and extension cable.