Setup
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
Product Specification
Side Discharge Installation
1. Insert bolt into the deck and side discharge hole with
2 x M6 x16 bolts and fasten it with 2 x M6 screw
nuts.
Figure5
Component
Rated Speed
Displacement
Cutting Width
Height Adjustment
Wheels
Machine
Weight
Safety & Instruction Decals
Important:
Safety & instruction decals are located near
areas of potential DANGER. Replace damaged decals.
1. WARNING: Read the Operator
’
s Manual.
2. Thrown Object Hazard: Keep bystanders a safe distance
from the mower.
3. Cutting/Dismemberment Hazard of Hand or Foot, Mower
Blade: Disconnect the spark plug wire and read the
instructions before servicing or performing maintenance.
4. Cutting/Dismemberment Hazard of Hand or Foot, Mower
Blade: Stay away from all moving parts and keep all
guards and shields in place.
5. Cutting/Dismemberment Hazard of Hand or Foot, Mower
Blade: Do not mow up and down slopes, only mow
across; stop the mower and engine, pick up debris before
operating; look behind and down before reversing.
•
Do not damage the cables when folding or unfolding
the handle.
•
If a cable is damaged, Contact an Authorized Service
Center by calling 1-866-591-8921.
Specification
2800RPM
1
50
cc
20”
Single Lever Height Adjustment
For Each Wheel
7” Front 7” Rear
61 lbs
3
Figure 1
Figure 3
Handle Installation
1.
Attach the mounting hole to the limit pin.then jam the
limit pin with a pin
.
2
.
Position the upper mower handle to match the lower
handle pre-drilled holes. Insert the bolt with a washer and
handle knobs. Hand tighten to secure the handle.
Wheel
Installation
1.
Install the washer
wheels and nutts
onto the
bolts
.
Figure3
2.
the
n
place wheel cover
by tapping it in
.
Figure4
Figure
4
Figure
5
Figure
2
