Pulsar MicroFlow-i, Инструкция по эксплуатации

Страница: 24 / 56

Page
18
Terminal Connection Details
Terminal Connections
Power
The MicroFlow-i operates from a DC voltage supply of 10-28 volts, and should
be installed and connected in accordance with ‘ Chapter 2–Power supply
requirements
’ and the instructions below. When wiring the
MicroFlow-i you
should use a twisted pair cable. The wire coding is shown below for ease of use
when connecting the
MicroFlow-i to monitor flow velocity:
You can also use Pulsar’s
MicroFlow-i HART PC software to interrogate and
obtain readings from the device. Please refer to Chapter 6 MicroFlow-i HART
PC for more details on how to use it.
Important Information
If the equipment is installed or used in a manner not specified in this
manual, then the protection provided by the equipment may be impaired.
Bootlace
Ferrules
MicroFlow-i cable
110 mm
Heat Shrink
Power +10-28 VDC (Red cable)
0 Volts (Black cable)
Screen (Green cable)