Pulsar MicroFlow-i, Инструкция по эксплуатации

Страница: 17 / 56

Page 11
Location
When choosing a location to mount the bracket and MicroFlow-i , note the
following:
•
For optimum readings, it is recommended that the MicroFlow-i should be
positioned at a 45° angle to the surface of the material being measured.
•
The mounting surface must be vibration-free.
•
The ambient temperature should be between -20ºC and 60ºC.
Mounting
For the best results it is highly recommended to use the MicroFlow-i angled
bracket, which is available from your Pulsar distributor, which will ensure that the
MicroFlow-i can be correctly installed. The bracket can be used if the MicroFlow-
i sensor is to be mounted on its own in a specific location or along with a Pulsar
dBi or dB level transducer. Please see ‘ Angled Mounting Bracket
’ for
dimensions of this bracket, please note that the drawing is not to scale.
‘
Mounting sensor to a bracket
’ illustrates how you would install the sensor to
one of Pulsar’s angled brackets.
The MicroFlow-i angled bracket should be mounted by marking and drilling the
holes suitable for fixing your screws/bolts (length to suit your application) and
then fixing the bracket in place.
Important Information
When installing the MicroFlow-i it is recommended that it is mounted at
least 1m away from moving persons or machinery.
All electronic products are susceptible to electrostatic shock,
so follow proper grounding procedures during installation.