Pulsar FORWARD FN455S, Руководство пользователя

Страница: 23 / 83

7. Mount the adapter with the insert into the lens of the optical device (17).
8. Move the lever (22) from its initial OPEN position to the CLOSE position.
9. Ensure that the adapter fits snugly against the lens.
10. If there is any gap, do the following:
Loosen the locking screw(20) with an Allen key (S=2mm).
Tighten the screw (21) with an Allen key (S=4mm) with the force
necessary to ensure that the adapter fits tightly against the lens. The
clamping forces should be 1 Nm.
Tighten the locking screw(20).
11. The effort can be tested with a torque screwdriver.
12. Insert the digital module firmly into the adapter so that the pins located
in the adapter case fit into the grooves (23) of the digital module. Turn the
digital module clockwise as far as it will go. The triangular mark on the
digital module and the square on the adapter body must be aligned.
13. To align the digital module, turn the handle(22) to the OPEN position
and align the digital module with the horizon.
Selection table for optical device insert rings
Cover adapter
model
The internal diameter of the insert
needs to match the outer diameter of
the objective lens housing of the
daylight optical device it is being
installed on.
Insert internal
diameter, mm
Suitable for lens
housing of
daylight optical
devices with an
outer diameter
of, mm