Pulsar Flow Monitor, Инструкция по эксплуатации

Страница: 52 / 61

Page
46
System Parameters
Passcode
P921 Enable Code
Enables the passcode ( P922 ), which means the passcode must be entered to
go into program mode. If disabled (set to 0 ), then no passcode is required,
and
ENTER
is used to enter program mode. Default = 1 (Enabled)
P922 Passcode
This is the passcode that must be used to enter program mode. The default
is 1997 , but this can be changed to another value from 0 to 9999.
System Information
The following three parameters do not affect how the unit performs, but
details contained within them may be required, by Pulsar, when making
technical enquiries.
P926 Software Revision
This parameter will show the current software revision
P927 Hardware Revision
This parameter will show details of the current hardware revision
P928 Serial Number
This parameter will show the serial number of the unit.
P929 Site Identification
This parameter allows you to give each unit an individual reference number,
for identification purposes. You can set any number between 1 and 99999.
P930 Factory Defaults
This parameter resets all parameter values to the original Factory Set values
that were installed when the unit was tested, before despatch to you.
To reset parameters, enter 1 ( Yes ), and press
ENTER
, then you will see a
message “
Entr if sure
”, you should press
ENTER
again. If you press any
other key at this point, the parameters will not be reset, and you will see a
message confirming this.
Once you have done this, program the unit, to the desired application.