www.pulsar.pl
DSO-PRA
16
Shock protection circuit shall be performed with a particular care, i.e. yellow and green wire coat
of power cable shall stick to one side of terminal - marked with symbol on PSU enclosure. Operation of
PSU without the properly made and fully operational shock protection circuit is UNACCEPTABLE! It can
cause a device failure or an electric shock
.
6. After connections are correctly made, perform system checking procedure according to
instructions of control panel manufacturer.
WEEE LABEL
Waste electrical and electronic equipment must not be disposed of with normal household waste. According to
the European Union WEEE Directive, waste electrical and electronic equipment should be disposed of
separately from normal household waste
In Poland, according to the European Union WEEE Directive, waste electrical and electronic equipment, marked with a crossed
out wheeled bin symbol, should be disposed of separately from normal household waste. The user is obliged to throw the end-
of-life equipment in a WEEE collection point. WEEE collection points are run by wholesale and retail sellers of this equipment,
and municipal organizational units operating in the field of collecting municipal waste.
The proper implementation of these obligations is particularly important when the waste equipment contains hazardous
components which have a negative impact on the environment and human health.
CAUTION!
The DSO uses sealed lead acid batteries (SLA). Used batteries must be disposed of in accordance with the
applicable regulations.
The warranty conditions can be found at:
THE WARRANTY CONDITIONS FOR SLA BATTERIES
- Additional arrangements
The presented warranty conditions for SLA batteries are valid in conjunction with
1.
The battery will not be considered defective if its capacity during the warranty period has not dropped to
80 [%]
of the rated capacity.
2.
The periodic maintenance of all batteries, including performing the appropriate measurements, shall be performed every
12
months
from the installation. The measurement report, prepared in accordance with the guidelines contained in the "Installation" section,
should be sent within two weeks to the company's e-mail address
. Presentation of the measurement results from all of
required periodic maintenances is a
condition for warranty claim
.
3.
The warranty applies only to batteries designed for
buffer operation. Cyclic batteries are not covered by this warranty.
4.
The warranty period will be reduced by 50 [%] for each sustained temperature rise of 8 [°C] above nominal operating temperature of
the battery of 25 [°C].
5.
The PULSAR company
is not responsible for:
- Batteries with unreadable serial number;
- Damages resulting from improper charging or installation;
- Mechanical damages to the enclosure and polarity terminals (clamp caps) caused by the installation, commissioning, and operation of
the batteries;
- Damages caused by fire, high temperature (overheating), explosion, or freezing;
- Damages caused by misuse or negligence;
- Damages caused by force majeure.
6.
The PULSAR company reserves the right to verify battery operating conditions by reading the operating history of the DSO power
supply system. The data can be read remotely or locally by employees of the PULSAR company
7.
In the case of unjustified claim, the claimant may be charged with the travel and manhour costs of a PULSAR employee incurred by the
PULSAR company.
8.
The warranty is valid only upon presentation of the invoice and delivering the battery subjected to complaint along with a description of
the defect at the expense of the claimant.
Pulsar sp. j.
Siedlec 150, 32-744 Łapczyca, Poland
Tel. (+48) 14-610-19-40, Fax. (+48) 14-610-19-50
e-mail:
