www.pulsar.pl
BNC08128
G
REEN POWER CCTV BNC
2
PSU features:
•
supply output 8x1A/12V DC
•
output voltage adjustment 12V÷15V DC
•
wide range of supply voltage: 176÷264V AC
•
high efficiency: 83%
•
8 outputs protected with 1A fuses
•
jumper selectable fuse type: fuse or polymer
fuse
•
voltage control at the AUX1 ÷ AUX8 outputs
•
BNC connectors for connecting the video signal
•
LED optical indication
•
FPS technical output – indication of the
output fuse activation– relay and OC type
•
protections:
•
SCP short-circuit protection
•
OVP overvoltage protection
•
Surge protection
•
Antisabotage protection
•
OLP overload protection
•
warranty – 2 year from the production date
TABLE OF CONTENTS:
1. Technical description.
1.1. General description
1.2. Block diagram
1.3. Description of components and connectors of the PSU
1.4. Technical parameters
2. Installation.
2.1. Requirements
2.2. Installation procedure
3. Power supply operation indication.
3.1. Optical indication
3.2. Technical outputs
4. Service and operation.
4.1. Overload or short-circuit of the power supply output
4.2. Maintenance
1. Technical description.
1.1. General description.
The PSU BNC08128 is intended for uninterrupted supply of CCTV systems requiring stabilized
voltage of 12V DC .
The output voltage can be adjusted with a potentiometer between 12V and 15V DC.
The power supply unit enables transmitting power and video using a 75 ohm coaxial cable integrated with two
power wires (YAP type). Additionally, it is equipped with BNC sockets for connecting the video signal. The
power supply outputs are independently protected by melting fuses or PTC polymer fuses. Failure (short
circuit) in the output circuit will activate the melting fuse or PTC fuse and disconnect the circuit from DC power
(+ U). Fuse failure is indicated by switching off the corresponding LEDs: L1 for AUX1, etc. In addition, the FPS
output (hi-Z state) and LFPS LED are activated and the relay contacts change their position. The PSU is
housed in a metal enclosure with signaling panel equipped with a microswitch indicating door opening (front
cover).
1.2. Block diagram.
Figure 1. Block diagram of the PSU.
