PISA-B-8CL2-B1
PISA-B-8CL2-B4
Apr. 2021 / Rev. 0.1 DS-PISA-B-8CL2-Bx-xx-EN
www.pulspower.com
8 / 19
All parameters are specified at 24Vdc input voltage, 8x3.75A output currents, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.
7.
Control And Monitoring Features
The LED matrix display provides information about the actual current values (average and peak) of the individual output
channels, reports faults and helps to parameterise the device. The green and yellow LEDs indicate the actual channel current
in percent of the nominal value. Peak values are stored in a peak detector and are additionally shown with one LED for a
short period of time. Red LEDs (regardless of whether they are flashing or solid on) indicate that the output is switched off.
The tripping characteristic can be set as a common parameter for all channels. To change the characteristic alternately
push the SET and channel control button for channel 3 at the same time. The selected option is shown on the LED matrix
for 2 seconds. Letter F indicates the fast and the letter S the slow tripping characteristic. If only the SET button is pressed,
the characteristic is displayed for 2s. Tripping characteristic can be changed regardless of whether a channel is switched
off or not.
Tripping characteristic setting can be protected against changes with a PIN code. To lock the settings push the SET and
channel control button 1 until the unit shows a moving text “PIN TO LOCK”. Enter a 4-digit PIN by pushing any combination
of channel control buttons 1-8. Push the SET button to save the PIN, the unit shows a moving text “LOCKED”. To unlock
settings push the SET and channel control button 1, the unit shows a moving text “PIN TO UNLOCK” and enter the 4-digit
PIN you selected and confirm it by pushing the SET button.
Fig. 7-1: Control and monitoring elements
Special Key Combinations
Special shortcuts allow quick access to certain information:
Press SET + CCB1 button: Lock/Unlock setting with PIN
Press SET + CCB2 button: Show FW version
Press SET + CCB3 button: Slow/Fast mode
