CS5.243
C-Line
24V,
5A,
S
INGLE
P
HASE
I
NPUT
Nov. 2020 / Rev. 2.1 DS-CS5.243-EN
All parameters are specified at 24V, 5A, 120Vac, 60Hz, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone +49 89 9278 0 Germany
8/26
6.
O
UTPUT
Output voltage
nom.
24V
Adjustment range
24-28V
guaranteed
max.
30V
***)
at clockwise end position of potentiometer
Factory settings
typ.
24.1V
±0.2%, at full load, cold unit,
Line regulation
max.
70mV
90-132Vac
Load regulation
max.
100mV
static value, 0A
5A; see Fig. 6-1
Ripple and noise voltage
max.
50mVpp
20Hz to 20MHz, 50Ohm
Output current
nom.
5A
at 24V, ambient temperature <60°C, see Fig. 6-1
nom.
6A
*)
at 24V, ambient temperature <45°C
nom.
3.75A
at 24V and 70°C ambient temperature
nom.
4.3A
at 28V, ambient temperature <60°C, see Fig. 6-1
nom.
5.1A
*)
at 28V, ambient temperature <45°C, see Fig. 6-1
nom.
3.2A
at 28V and 70°C ambient temperature
Reduce output current linearly b45°C and +70°C
Output power
nom.
120W
continuously available
nom.
144W
*)
Power Boost
® *)
Overload behavior
continuous current see Fig. 6-1
Short-circuit current
min.
10A
**)
load impedance <200mOhm, see Fig. 6-1
max.
14A
**)
load impedance <200mOhm, see Fig. 6-1
Output capacitance
typ.
1 800µF
included inside the power supply
*)
Power Boost
This power/ current is continuously allowed up to an ambient temperature of 45°C.
Above 45°C, do not use this power/ current longer than a duty cycle of 10% and/ or not longer than 1 minute every 10 minutes.
**)
Discharge current of output capacitors is not included.
***)
This is the maximum output voltage which can occur at the clockwise end position of the potentiometer due to tolerances. It is not a
guaranteed value which can be achieved. The typical value is about 28.5V.
Fig. 6-1
Output voltage vs. output current,
typ.
Output Voltage
0
0
4
8
4
8
12
28V
16
20
24
12A
10
6
2
Adjustment
Range
Output Current
