INSTALLATION
TM-1300 Progressive Scanning High Resolution Camera
Page 7
2.2.2 Rear Panel
FIGURE 2.
TM-1300 Rear Panel
2.2.3 Power Supply and Power Cable Setup
2.2.3 (a) Power Supplies
PULNiX recommends the following power supplies:
K25-12
110V AC/12V DC
2.1A power supply
P-15-12
220V AC/12V DC
2.1A power supply
K50-12
110V AC/12V DC
4.2A power supply
PD-12P
110V AC/12V DC
0.5A power supply
For users providing power through the 12-pin connector, the PD-12P power supply is available with the
12-pin mating connector already attached to the leads from the power supply. The PD-12 power supply
can be connected to the PULNiX power cable via a terminal strip or directly.
If wiring the PD-12 power supply directly, please note the following:
•
Twist the lead ends together and tin solder for strength and electrical continuity.
•
Use shrink tubing or a similar insulator to prevent exposed leads from touching.
•
The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.
•
Properly insulate all connections to prevent shorting.
2.2.3 (b) Using PULNiX Power Cables
If you are using PULNiX power cables, such as the 12P-02, KC-10, etc., please refer to the pin-out
diagram. The color coded leads use Grey for Ground and Yellow for +12V DC.
SHUTTER
MODE
UP
DWN
VIDEO
POWER
0
1
2
3
4
56
7
8
9
0
1
2
3
4
5
6
7
8
9
B
A
C
E
D
F
DIGITAL
SVGA
