FILTER BAG
Check bag from time to time. When bag is over
fi
lled with dirt the cleaner
will not operate at full ef
fi
ciency.
CAUTION: Very
fi
ne materials such as builders dust,
fl
our, cold
ash (never suck up hot ash) or soot will greatly reduce air
fl
ow and
suction through the bag even though it is only partially full. When
the cleaner is used to remove material of this nature, change the
bag immediately after or as necessary during extended cleaning.
Replacement
fi
lter bags can be purchased from the distributor where
you purchased your cleaner.
NOTE: For better dust control, mocro
fi
ber dust bags can also be
purchased from the distributor where you purchased your cleaner.
Large Biodegradable Paper Bags (pack of 10)
Part No: B100501
Extra Large Biodegradable Paper Bags (pack of 10)
Part No: B100538
High Ef
fi
ciency Micro
fi
ber Dust Bags (pack of 10)
Part No: B100628
REPLACING FILTER BAG
Disconnect cleaner from electrical source.
1. Unlock top assembly by pulling out the two side locks. Lift out the
fi
lter. Remove dust bag by holding the collar and gently rocking
while pulling away from the inlet nozzle.
2. On removal of bag, fold tab on collar back to seal hole and place
in tank.
3. To
fi
t a replacement dustbag hold the edges of the bag card collar
and slide onto the inlet nozzle while gently moving up and down to
ensure it goes along the full length of the nozzle and as close as
possible to the tank casing.
4. Ensure
fi
lter is clean and dust free on underside and re
fi
t. Carefully
replace machine top assembly in its correct position an push in the
two locks.
MAINTENANCE
Familiarize yourself with these easy maintenance tasks as proper use and care of your cleaner
will ensure continued best cleaning effectiveness.
WARNING:
Do not use the machine without dust bag and
fi
lter in place as damage to your cleaner motor unit will occur
5
