Pulch + Lorenz 150.600, Руководство пользователя

Страница: 20 / 67

KL 1600 LED – Operating instructions
8/11
2.4 Light intensity setting
The brightness can be adjusted continuously by turning the
light intensity setting knob (1).
Six-step intensity control is possible, from 0 – 5.
The highest brightness is reached at the end stop at
position 5.
When the brightness control is set at 0 there is no more
brightness, i.e. the lamp is off.
Attention: Please note that when the brightness control is
set at 0 the instrument is not switched off. When the
instrument is switched on the green control light (11) is lit. To
switch off the KL 1600 LED by pressing the on/off switch (2)
once (see point 2.3 “Start-up procedure”). Please ensure
safe power disconnection by pulling out the power plug!
2.5 Filter slide
The KL 1600 LED has a filter slide (8) which can be fitted with an insert filter from the filter set
(available as accessory).
When operating the light source the filter slide must always be engaged in one of the end positions
or in the rest position. This is the only way to guarantee optimum air cooling of the light source.
Operating the light source with the filter slide in an intermediate position can cause damage to the
slide.
Fitting the filter slide
Please ensure the filter slide (8) has cooled down before fitting the insert filter.
Completely pull out the filter slide (8) from the light source so that the label is legible. Insert the filter
with 28 mm diameter using lint-free gloves from top right behind the two retaining lugs and fix it with
slight pressure. The filter is then lying flat inside the holder.
To remove easily bend the bracket to the left and remove the filter with gloves.