RoIP-102 User Manual
VIII. Application Examples
Example 1:
Linking up two MOTO GM300 Radio terminals in peer-to-peer mode with two
RoIP102. The network access method is ADSL.
Operating procedures:
i.
Connect the PTT Interface of the radio terminal (GM300) with the PTT Interface Cable as
shown in the diagram below.
port of the RoIP102.
Connect the RJ-11 plug of the PTT Interface Cable to PTT1
ii.
Connect the RoIP302 LAN port to an Ethernet port of the ADSL Router
iii.
Assign a fixed IP to the RoIP302 LAN port. This fixed IP must be in the same segment as
the LAN port of the ADSL Router.
For example: if the LAN of the ADSL Router has an IP
192.168.1.1, then the LAN port RoIP302 could be set to 192.168.1.101.
iv.
Configure the DMZ mode of the ADSL Router to fixed IP assigned to the RoIP302 LAN port.
For DMZ configuration, please refer to the User Manual of the Router.
v.
Login to the RoIP Webpage and program the Network Settings as shown below.
note that the DNS addresses should be programmed as provided by from your local ISP
Please
Network settings:
Domain name server address on the above map according to local service providers’ domain
name server address (DNS) to be adjusted.
