DVI /Audio Matrix Switcher 16x16
PTN Electronics Limited
12
www.PTN-electronics.com
[x1]
B[x2],[x3],[
x4].
Transfer both the video and the audio signals from the
input channel [x1] to the output channels [x2], [x3] and
[x4].
Status[x1].
Inquire the input channel to the output channel [x1].
Status.
Inquire the input channel to the output channels one by
one.
Save[Y].
Save the present operation to the preset command [Y].
[Y] ranges from 0 to 9.
Recall[Y].
Recall the preset command [Y].
Clear[Y].
Clear the preset command [Y].
Note:
1)
[x1], [x2], [x3] and [x4] are the symbols of input or output channels ranged
according to the model of the matrix switcher. If the symbols exceed the effective
range, it would be taken as a wrong command.
2)
I
n above commands, “[”and “]” are symbols for easy reading and do not need to be
typed in actual operation.
3)
Please remember to end the commands with the ending symbols “.” and “;”.
Detail Examples:
1. Transfer signals from an input channel to all output channels: [x1]All.
Example: “3All.” to transfer signals from the input channel No.3 to all output
channels.
2. Transfer all input signals to the corresponding output channels
respectively: All#.
After running this command, the status of it will be: 1->1, 2->2, 3->3,
4-
>4……16->16.
3. Switch off all the output channels: All$.
After running this command, there will be no signals on all the output channels.
4. Check the version of the firmware:
/^Version;
To check the version of the firmware.
5. Switch off the detail feedback command from the COM port: /:MessageOff;
I
t will leave the “switch OK” as the feedback, when you switch the matrix.
6. Switch on the detail feedback command from the COM port: /:MessageOn;
It will show the detail switch information when send the commands.
7. Transfer signals from an input channel to the corresponding output
channel: [x]#.
Example: “5#.” to transfer signals from the input channel No.5 to the output channel
