1. Measure length of oil pan. This determines where the cross-braces
(3) are attached to the frame (2). (See Fig.1)
2. With set screw holes facing inwards, slide 2 support uprights (4)
onto each cross-brace (3).
3. Attach casters (1) through frame (2) and cross-braces (3), with nut
(5), split washer (6), and flat washer
(7) at desired length based on
measurement in step 1. The length of
the cross-braces (3) should be a
minimum of 2 ‘’ and a maximum of 4’’
shorter than the overall length of the
oil pan. Tighten nut (5).
ASSEMBLY INSTRUCTIONS
SPECIFICATIONS
Capacity: .........................750 lbs.
Length: ............................. 21-3/4"
Width: ..................................... 18"
Height: .............................. 13-3/4"
PARTS LIST
1 Casters
4
2 Frame
1
3 Cross-Braces
2
4 Support Uprights
4
5 M12 Nut
4
6 M12 Split Washer
4
7 M12 Flat Washer
4
8 Set Screw
4
# Description
Qty.
# Description
Qty.
Read these safety warnings before operation.
WARNING!
Failure to heed these warnings may result in loss of load,
damage to engine stand, and/or engine stand failure resulting
in personal injury or property damage.
WARNING!
Do not overload engine stand beyond rated capacity.
Overloading can cause damage to or failure of the engine
stand.
Always use stand on hard, level surface capable of sustaining
the load. Use of stand on other than hard level surfaces can
result in stand instability and possible loss of load.
IMPORTANT SAFETY INFORMATION
1. Visual inspection shall be made before each use of the stands,
checking for cracks, cracked welds and missing and/or damaged
parts. Any stand that appears to be damaged in any way shall be
removed from service immediately.
2. BECAUSE OF THE POTENTIAL HAZARDS ASSOCIATED WITH
THE MISUSE OF EQUIPMENT OF THIS TYPE, NO
MODIFICATIONS SHALL BE MADE TO THE PRODUCT.
3. Replace worn or damaged parts with Performance Tool replacement
parts. Be sure that only qualified personnel perform repairs.
MAINTENANCE & INSPECTION
1
2
3
4
5 6
7
8
4. With the engine still being supported by hoist, lower the engine close
enough to the stand to properly determine width of support uprights
(4). Install set screws (8) into support uprights (4) and tighten.
5. Slowly lower engine onto stand. Using the straps provided, secure
the engine to the stand before removing hoist.
Fig.1
