A
A
C
C
T
T
A
A
n
n
g
g
l
l
e
e
p
p
o
o
t
t
r
r
e
e
p
p
l
l
a
a
c
c
e
e
m
m
e
e
n
n
t
t
1.
Carefully fold the pcb over to access the angle pot on the back side of the pcb. Do not
let the pcb hang from the wiring, which will result in damage to the A-2-B or other
wiring.
2.
Loosen the three screws using a small flat tip screwdriver backside of pcb and a 5mm
wrench on the front side of the pcb to remove the angle pot. Remove the wiring from
the terminal strip. Now replace the angle pot in the same orientation as the one that
was removed (make note of where the wires come out of the pot). Connect the wiring
and see page 11 for adjustment or proceed to page 26 for length procedure.
Angle Pot
Terminal strip
5 mm nuts
