Figure 2
3. Attaching the GPS/HSPA+ End-Cap
•
Run the cables (x3) and scanner/imager flex cable through the opening at the top of the expansion back cover.
•
Using a Torx T10 screwdriver and the four screws provided (M3 x 6 mm), secure the GPS end-cap to the expansion
back cover. Torque to 5 in-lb (0.56 N-m).
4. Reassembling Omnii
•
Before reattaching the back cover, connect the pistol grip trigger/speaker wire harness to socket J11 on the main
logic board. Connect the camera flex cable to socket J9 on the main logic board.
•
If a scanner/imager flex cable is present in the end-cap, connect it to socket J13 on the main logic board as shown in
Figure 3. If no cable has previously been installed in this socket, there may be a piece of “dummy” stiffener that must
be removed before inserting the cable.
•
Make certain the GPS bypass cable is connected (see Figure 2 on the previous page).
Figure 3
•
Fit the back cover in place against the main housing, ensuring that no cables are caught in the seal.
•
Using a Torx T10 screwdriver, tighten the eight screws (M3x6 mm) to a torque of 5 in-lb (0.56 N-m). Install the screws
in the sequence shown in Figure 1 on the previous page to ensure a consistent seal around the opening.
•
Using a Torx T6 screwdriver, replace the two screws (M2x8 mm) above the display on the front of the unit. Torque to
2.5 in-lb (0.28 N-m).
•
Through the scanner pod opening, use small needle-nose pliers to route the
grey
GPS antenna cable under the two
metal cable restraints on the left side of the GPS module.
•
Press the grey GPS antenna connector into the socket labelled
GRY
on the left side of the unit. Snap it into place.
•
Through the scanner pod opening, use small needle-nose pliers to route the
black
HSPA+ radio antenna cable under
the metal cable restraint at the top of the radio module.
•
Press the black HSPA+ antenna connector into the socket labelled
BLK
on the radio module. Snap it into place.
•
Press the
green
diversity cable connector into the socket labelled
GRN
.
•
Affix regulatory label 1004434.
•
Reattach the blanking plate using a Torx T10 screwdriver and four screws (M3x5 mm) to 5 in-lb (0.56 N-m).
•
Install the battery.
100-pin connector
Torx T6 screws (x3)
GPS bypass cable
J13
J9
J11
Flip latch open
Insert cable
Flip latch closed
GPS antenna
connector
HSPA+ antenna
connector
Metal cable restraint
Diversity antenna
connector
Affix regulatory label here
COMPANY HEADQUARTERS
SUPPORT SERVICES
Psion Inc.
For local support services, go to:
2100 Meadowvale Boulevard, Mississauga
http://www.psion.com/service-and-support.htm
Ontario, Canada L5N 7J9
Tel:
+1 905 813 9900
Fax:
+1 905 812 6300