Psiber Data Systems NETWORK IP TESTER, Руководство пользователя

Страница: 4 / 9

PING, “Dupe IP Error” is displayed indicating a duplicate IP address is
present on the network. If no PING response is received within ten
seconds, “No Response” is displayed. When the PINGed IP address is
in a different subnet than the Pinger IP address, the unit first attempts to
locate the default gateway. If the gateway does not respond, the Pinger
displays a “No Gateway Found” message indicating either the gateway
is not functioning properly or an incorrect gateway IP address was
entered. When a gateway is located, a “Gateway Found” message is
displayed and the PING test continues as described above. When a
PING response is received from another subnet, the MAC address of the
Gateway is shown (GW MAC) when the Info key is pressed.
Note: When the IP address of the device being PINGed is in the same
subnet/VLAN as the IP address of the Pinger, the Subnet Mask can be
“ON” or “OFF” and a Gateway IP address is not required. When the IP
address is in a different subnet/VLAN, the Subnet Mask must be “ON”
with the mask entered and the IP address of the Gateway must be
entered. (See Subnet Mask Setup and Gateway Setup)
IP LIST SCREEN
When “List” is selected and the PING function key is pressed, each
IP address stored in the IP List (see IP List Setup) is PINGed in turn.
The same “Waiting” and “No Response” messages are displayed as
described above.
After completing the PING of the last stored IP address, the IP List
Reponse screen is presented.
IP LIST RESPONSE SCREEN
The IP List Response screen shows the results of the PING to each of
the stored IP addresses.
The Up/Down cursor key is used to scroll through each IP address with
Round Trip Time, Data status and MAC address presented for IP ad-
dresses that are found or “No Response” for IP addresses that did not
respond within ten seconds. Times that are less than one second are
shown in milli-seconds (ms).
IP RESPONDER MODE
The Pinger will respond to a PING request that is sent to the unit’s
IP address. When the unit is in the LINK Screen showing speed/polarity,
a PING to the Pinger IP address presents the PING Received screen.
The Ping Received screen shows the IP and MAC addresses of
the PING source. The data packet in the PING request is limited to no
more than 128 bytes or else the request will be discarded by the Pinger.