PS Engineering
PMA8000B-MP3Avidyne Version (-0403) Audio Selector Panel and Intercom System
Installation and Operator’s Manual
200-890-0403
Page 2-1
Rev. 4, Jan. 2011
Section II - INSTALLATION
2.1 GENERAL INFORMATION
2.1.1
SCOPE
This section provides detailed installation and interconnection instructions for the PS Engineering
PMA8000B-MP3 Audio Selector Panel/Intercom/ with internal Marker Beacon.
Please read this manual carefully before beginning any installation to prevent damage and post -
installation problems. Installation of this equipment requires special tools, test equipment (refer to section
2.12.1) and knowledge as required by 14 CFR 65.81 (b).
Refer to Avidyne Entegra Integrated Avionics System Installation Manual for full systems interconnect.
2.1.2
Certification Requirements
NOTE
The PMA8000B-MP3 requires specialized knowledge and tools for an effective installation. An appropr i-
ately rated Certified Aircraft Repair Station
must
install this equipment in accordance with applicable
regulations. PS Engineering, Incorporated warranty is not valid unless the equipment is installed by an
authorized PS Engineering, Incorporated dealer.
Failure to follow any of the installation instructions, or installation by a non -certified individual or agency
will void the warranty, and may result in an
unairworthy
installation.
2.2 Unpacking and Preliminary Inspection
Use care when unpacking the equipment. Inspect the units and parts supplied for visible signs of shipping
damage. Examine the unit for loose or broken buttons, bent knobs, etc. Verify the correct quantity of
components supplied with the list in Section 1.6 (B). If any claim is to be made, save the shipping mat e-
rial and contact the freight carrier. Do NOT return units damaged in shipping to PS Engineering. If the
unit or accessories show any sign of external shipping damage, contact PS Engineering to arrange for a
replacement. Under no circumstances attempt to install a damaged unit in an aircraft. Equipment returned
to PS Engineering for any other reason should be shipped in the original PS Engineering packaging, or
other UPS approved packaging.
2.3 Equipment Installation Procedures
2.3.1
Cooling Requirements
Forced air-cooling of the PMA8000B-MP3 is not required. However, the units should be kept away from
heat producing sources (i.e. defrost or heater ducts, dropping resistors, heat producing avionics) without
adequate cooling air provided.
2.3.2
Mounting Requirements
The PMA8000B-MP3 must be rigidly mounted to the instrument panel of the aircraft structure, within
view and reach of the pilot position(s). Installation must comply with FAA Advisory Circular AC 43.13-
2B. The unit may be mounted in any area where adequate clearance for the unit and associated wiring
bundle exist.
To prevent noise, avoid installing the unit close to high current devices or systems with high-voltage pulse
type outputs, such as DME or transponders. Avoid running the interconnecting bundles near any high
current wires.
