4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 [email protected] www.psaudio.com
®
Getting Started
Owner’s Reference
UPC Power Center
Getting Started 1
©2004 PS Audio International Inc. All rights reserved.
Once your new UPC-200 is unpacked, you’ll need to fi nd a convenient place to set it.
There are several ways to mount the UPC-200: on a rack shelf, on the fl oor behind the equipment, or
simply on a shelf next to the powered equipment.
If the UPC-200 is to be placed on the fl oor or carpet, make sure the unit is not going to come in
contact with water or cleaning solvents.
The UPC-200 can benefi t from aftermarket isolation devices such as cones, spikes and Sorbothane
pads.
Once you have chosen the location for the UPC-200 you can use the supplied AC power cord to
connect it to the AC wall receptacle or you can use an aftermarket power cord and receptacle.
We strongly recommend the use of a PS Audio xStream Power
™
AC cable and a PS Power Port
™
AC
receptacle to feed the UPC-200 power. While the supplied power cable is adequate for the task it is
not going to provide the best performance. Choosing any xStream Power cable will make a signifi cant
performance improvement over the stock power cable.
If you are using additional power conditioning equipment, such as a PS Audio Power Plant, it is
recommended that the UPC-200 be placed after the Power Plant and used to isolate equipment
connected and powered by the Power Plant.
Isolation
Power Cables
Location
Cautions
Conditioners
